Cadillac CTS key fob battery

Separate remote fob

1. This remote is its own fob, separate from the metal key, which makes it one of the easier ones to open.
2. Look for a screw on the back or a notch on the edge. Remove the screw if present, then twist a coin in the notch to split the case.
3. Replace the cell, keeping the + side where it was, and check the small metal tab still touches it.
4. Snap the case shut and watch for the lights to flash when you press lock at the car.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Most push-button fobs hide a metal backup key. Press or slide its catch and draw the key out first.
2. The gap left by the metal key usually has a pry point. A slow twist with a thin flat tool (tape on the tip saves the plastic) opens the two halves.
3. Pop the old battery out with a toothpick or plastic pick, not a metal blade, and seat the new one with the + side matching the old one.
4. Reassemble, refit the emergency key, and check that the car sees the fob when you press start.

Cadillac smart remotes commonly hide a key behind a side button. With it out, the case opens at the bottom slot.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.