Hyundai Santa Fe key fob battery

Separate remote fob

1. The remote is a small standalone unit. You will not need to touch the ignition key at all.
2. Turn it over: some older fobs use one small screw, newer ones just clip. Pry at the seam once any screw is out.
3. Replace the cell, keeping the + side where it was, and check the small metal tab still touches it.
4. Close the fob and test it. If it does not work, open it again and check the cell is seated flat.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Start by freeing the hidden metal key: there is a latch or slide on the case, and the blade comes out once it moves.
2. Use the slot where the metal key sat. Twist, do not lever hard, and work along the seam until the halves separate.
3. Before you take the old cell out, look at its face. Put the new cell in with the same side showing, and avoid touching both faces at once.
4. Close the case until it clicks all the way round, put the metal key back, then try the buttons and a push-button start.

Hyundai smart keys usually have a button that releases the mechanical key; a flat tool in the gap then opens the case.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

A CR2450 is 24.5 mm across and 5.0 mm thick, much fatter than a CR2032. A thinner cell will rattle and lose contact, so buy the exact size.

Flip key

1. Swing the key blade open first. On most flip keys the cell lives in the body behind the hinge.
2. Some flip keys have a screw on the back; others just clip. Remove the screw if there is one, then pry gently at the seam.
3. Take out the old cell, noting which side faced you, and fit the new one the same way.
4. Press the halves together until no gap shows, then try every button.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.