Hyundai Tucson key fob battery

Separate remote fob

1. The remote is a small standalone unit. You will not need to touch the ignition key at all.
2. Find the slot along the edge and turn a coin in it. Go slowly so the clips do not snap.
3. Replace the cell, keeping the + side where it was, and check the small metal tab still touches it.
4. Snap the case shut and watch for the lights to flash when you press lock at the car.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
2. Look inside the empty key slot for a notch. Put the tip of the metal key or a small flat screwdriver wrapped in tape there and twist gently until the shell splits.
3. Before you take the old cell out, look at its face. Put the new cell in with the same side showing, and avoid touching both faces at once.
4. Close the case until it clicks all the way round, put the metal key back, then try the buttons and a push-button start.

Hyundai smart keys usually have a button that releases the mechanical key; a flat tool in the gap then opens the case.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

A CR2450 is 24.5 mm across and 5.0 mm thick, much fatter than a CR2032. A thinner cell will rattle and lose contact, so buy the exact size.

Flip key

1. Swing the key blade open first. On most flip keys the cell lives in the body behind the hinge.
2. Find the seam or small slot on the body (often at the end away from the blade) and twist a coin or small flat screwdriver in it until the cover lifts.
3. Lift the cell out with a plastic tool and press in the new one with the + side matching.
4. Clip the body closed, fold the blade, and test the buttons from a few steps away.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.