Lexus GX key fob battery

Key with remote in the head

1. This type has the buttons built into the key head. The cell is inside that head, between two clipped halves.
2. Work a thin flat tool into the seam near the blade and twist; go round slowly if it does not open at once.
3. Inside you may find a small circuit board in a tray. Lift the board out if the cell is underneath, swap the cell with the same side up, and refit the board.
4. Snap it closed and press each button. The car still starts with a dead remote battery on most of these keys, because the start chip needs no battery.

A CR1616 is 16 mm across and 1.6 mm thick. It is easy to confuse with the 20 mm CR20xx sizes, which will not fit.

Smart key (push-button start)

1. Most push-button fobs hide a metal backup key. Press or slide its catch and draw the key out first.
2. Use the slot where the metal key sat. Twist, do not lever hard, and work along the seam until the halves separate.
3. Pop the old battery out with a toothpick or plastic pick, not a metal blade, and seat the new one with the + side matching the old one.
4. Reassemble, refit the emergency key, and check that the car sees the fob when you press start.

Lexus smart keys usually hide the metal key behind a release button; the cover opens from the notch next to where the key sat.

A CR1632 is 16 mm across and 3.2 mm thick. It is easy to confuse with the 20 mm CR20xx sizes, which will not fit.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.