Nissan Versa Note key fob battery

Key with remote in the head

1. This type has the buttons built into the key head. The cell is inside that head, between two clipped halves.
2. Find the seam around the head. Twist a coin or small flat screwdriver in the notch at the blade end or side until the halves part.
3. The coin cell is usually under or on the back of a small board. Keep the rubber button pad in place while you swap the cell.
4. Close the head, check there is no gap, and try the buttons.

A CR1620 is 16 mm across and 2.0 mm thick. It is easy to confuse with the 20 mm CR20xx sizes, which will not fit.

Smart key (push-button start)

1. Start by freeing the hidden metal key: there is a latch or slide on the case, and the blade comes out once it moves.
2. Use the slot where the metal key sat. Twist, do not lever hard, and work along the seam until the halves separate.
3. Before you take the old cell out, look at its face. Put the new cell in with the same side showing, and avoid touching both faces at once.
4. Reassemble, refit the emergency key, and check that the car sees the fob when you press start.

Nissan Intelligent Keys normally hold a mechanical key behind a release knob. With the key out, a small screwdriver in the slot separates the halves.

A CR2025 is 20 mm across and 2.5 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.