Ford Escape key fob battery

Separate remote fob

1. A separate fob has no key blade inside, so it opens with nothing but a coin or a small screwdriver.
2. Look for a screw on the back or a notch on the edge. Remove the screw if present, then twist a coin in the notch to split the case.
3. Swap the cell or cells, keeping the same side up as the old ones.
4. Close the fob and test it. If it does not work, open it again and check the cell is seated flat.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Key with remote in the head

1. The remote electronics sit in the plastic head of the key itself, so there is no separate fob to open.
2. Many key heads split along the side seam. Start at the small notch and pry a little at a time.
3. Replace the cell with the same face showing, and make sure the rubber keypad sits flat before closing.
4. Close the head, check there is no gap, and try the buttons.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

Smart key (push-button start)

1. Find the small release on the edge or back of the fob and hold it while you pull out the metal emergency key.
2. Use the slot where the metal key sat. Twist, do not lever hard, and work along the seam until the halves separate.
3. Note which side of the old coin cell faces up (usually the side with the writing), lift it out with a plastic tool, and press the new one in the same way.
4. Reassemble, refit the emergency key, and check that the car sees the fob when you press start.

Ford intelligent access fobs usually have a release for the emergency key. The key blade itself fits the pry slot.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.

A CR2450 is 24.5 mm across and 5.0 mm thick, much fatter than a CR2032. A thinner cell will rattle and lose contact, so buy the exact size.

Flip key

1. Swing the key blade open first. On most flip keys the cell lives in the body behind the hinge.
2. Some flip keys have a screw on the back; others just clip. Remove the screw if there is one, then pry gently at the seam.
3. Lift the cell out with a plastic tool and press in the new one with the + side matching.
4. Close it up, check the blade still flips cleanly, and test the buttons at the car.

A CR2032 is 20 mm across and 3.2 mm thick. CR2032, CR2025 and CR2016 share the same width but not the same thickness, so a swap between them can leave a loose contact or a case that will not close.